帅帅的leo 发表于 2007-8-10 22:23

求助，各位老大。。麻烦看一下这是什么机器？

Babcock 5-Zone Horizontal Stenter<br /><br />With horizontal chain guide in steel chain frame with needle tension<br />Year 1989<br />W.Width:&nbsp;&nbsp;- 180 cm<br />Speed:&nbsp;&nbsp;up to 80 m/min.<br />The main elements of the equipment:<br /><br />Goods intake combination: 2 roller-Foulard<br /><br />5 Zone-stenter machine, system Artos 5303<br /><br />5 Zone - 2:2-Dryer with Icon-Air-exit combination<br /><br />Drive- and Switch gear-device<br /><br />Energy Recovery, Rotating air-to-air heat exchanger, Automation <br /><br />Gas heating, max. 290.000 Kcal/hour. each zone.&nbsp;&nbsp;Control range: 1:30<br /><br /> 1 CO2-Fire extinguisher-Device in the&nbsp;&nbsp;exhaust air duct, consisting of: <br /><br />Pipes for 2&nbsp;&nbsp;exhaust air sockets with CO2-Extinguisher-/Spray valves,&nbsp;&nbsp;Shut-off Valve, <br /><br />Temperature sensors and thermal switches at the exhaust air sockets<br /><br /> 1 Optical and acoustical alarm system for overheating over 240°

007sniper 发表于 2007-8-10 23:08

是拉幅定型机，是拉幅定型机

帅帅的leo 发表于 2007-8-11 20:27

能否帮我翻译一下内容？

帅帅的leo 发表于 2007-9-11 14:24

能否帮我翻译一下内容？<br /><br />[<i> 本帖最后由 帅帅的leo 于 2007-9-11 14:26 编辑 </i>]

007sniper 发表于 2007-9-15 21:29

你的照片上不是很清楚了吗，拉幅定型机，还带光电整纬呢！<br />具体的机器参数你可以深入基层和工厂的技术人员讨教，凡事要先靠自己呀，别人不能帮你代劳所有的事情呀！
页: [1]
查看完整版本: 求助，各位老大。。麻烦看一下这是什么机器？